Plain Cable Bolt

Cable bolt is made of grade 1860Mpa steel wires,which can be made into plain cable bolt and bulbed cable bolt.
Contact Now E-Mail Telephone WhatsApp
Product Details

Plain Cable Bolt Functions

Cable bolt could provide higher tensile strength,anti-shearing capacity and incomparable bending capacity,

and could prevent the lateral movement of strata.


Plain Cable Bolt Features&Advantages

Plain cable bolt

Available in single strand or twin strand

Fish hooks fitted to top of cables for retention prior to grouting

Resin could be applied for immediate point anchorage and grout for permanent support

                 Plain Cable Bolt

Plain Cable Bolt Mechanical Properties

Item No.TRCB152TRCB178TRCB189TRCB216TRCB218
Diameter(mm)15.217.818.921.621.8
Strands1*71*71*71*71*19
Mass per meter(kg)1.11.51.732.242.48
Cross sectional area(m)140191220285313
Steel Grade(Mpa)18601860186018601860
Tensile Strength(kN)260(26.5T)355(36.2T)409(41.7T)530(54.1T)583(59.5T)
Min 0.2% extension under load(kN)229311
360466513
Min Elongation(%)3.53.53.53.53.5


Plain Cable Bolt Accessories

Fish Hooks

Expansion shell

Grouting tube

Breathing tube

Bearing plate

                         Plain Cable Bolt

Plain Cable Bolt Application

Mines

Tunnels

Slopes

Places where need ground support

Plain Cable Bolt Length & Package

Length:500mm to 6200mm in pieces or in coils

Package:20 pcs each bundle

As customer’s requirement

             Plain Cable Bolt

How to work


        Assess the ground conditions thoroughly.

        

        Bore a hole based on the bolt's diameter and length, ensuring it's 200mm to 500mm shorter than the bolt itself.

        

        Fix a breather tube along the entire length of the bolt, allowing it to extend approximately two meters from the hole.

        

        Affix roughly one meter of grout tube to the cable bolt's end, leaving enough excess to connect to the pump.

        

        Place the cable bolt into the hole and seal it to prevent grout loss during pumping.

        

        Link the grout tube to the pump and submerge the breather tube in a water container. Start pumping and observe air bubbles escaping in the water. 

        Once the hole is filled and bubbles cease, the grouting is complete.

        

        Tension the cable bolt after the grout has set.



Leave your messages

Related Products

Popular products